The Challenges to Swim Spa Covers

Swim Spas represent distinct challenges when it concerns covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same factors a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot more difficult.
Getting a new swim spa is an amazing event in life. You’re anticipating the workout you’ll get from using it. Possibly you’re a little relieved to have actually lastly selected from the various models you took a look at. At any rate, you most likely weren’t thinking much about the cover you would use.
Normally, the cover that gets home with your brand-new purchase will be a four section rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style flaw. Integrated in obsolescence since as quickly as it is placed in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are very little as they increase from the water surface area. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It takes place gradually and on a Swim Spa Cover which is made from individual sections, at differing speeds. So eventually you’ll see a couple of of the areas are really getting heavy. The bar lifters on the ends of the swim spa aren’t much aid since you still have to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a new style for their Swim Spa Covers
Instead of using a number of foam panels to construct Swim Spa Covers that will ultimately end up in some land fill, they designed one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or break down at the joints either. So if you own a swim spa, and you intend to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to purchase today, bookmark this website so you can discover it once again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *