The Challenges to Swim Spa Covers

Swim Spas represent distinct challenges when it pertains to covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The difficulty is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an interesting event in life. You’re anticipating the exercise you’ll get from using it. Maybe you’re a little relieved to have actually finally selected from the various designs you took a look at. At any rate, you most likely weren’t believing much about the cover you would use.
Usually, the cover that comes home with your brand-new purchase will be a 4 area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it always does.
Every stiff foam filled Lightweight Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence since as quickly as it is positioned in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any difference. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are very little as they increase from the water surface area. They make their method into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.

It happens gradually and on a Lightweight Swim Spa Cover which is made of private sections, at differing speeds. So eventually you’ll discover a couple of of the sections are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much aid because you still have to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com created a different design for their Lightweight Swim Spa Covers
Instead of using several foam panels to construct Lightweight Swim Spa Covers that will eventually end up in some garbage dump, they designed one that utilizes air chambers that do not suck up wetness.
In fact SpaCap.com Lightweight Swim Spa Covers are easy to remove, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the Lightweight Swim Spa Cover for it.
If you’re not ready to purchase today, bookmark this site so you can find it again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *