The Challenges to Swim Spa Covers

Swim Spas represent distinct obstacles when it comes to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, getting rid of and changing the cover can be a lot harder.
Getting a new swim spa is an exciting occasion in life. You’re anticipating the exercise you’ll receive from using it. Possibly you’re a little relieved to have finally selected from the different models you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Typically, the cover that comes home with your new purchase will be a 4 area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style defect. Built in obsolescence due to the fact that as soon as it is positioned in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper won’t make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are really small as they increase from the water surface. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It takes place gradually and on a Swim Spa Cover which is made from private sections, at differing speeds. So eventually you’ll notice one or two of the areas are really getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance because you still have to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different style for their Swim Spa Covers
Instead of using numerous foam panels to develop Swim Spa Covers that will ultimately wind up in some garbage dump, they created one that uses air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or fall apart at the seams either. So if you own a swim spa, and you intend to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to purchase today, bookmark this site so you can discover it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *