Swim Spas represent distinct difficulties when it comes to covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same factors a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an exciting event in life. You’re anticipating the exercise you’ll receive from using it. Maybe you’re a little relieved to have lastly made a selection from the various models you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Normally, the cover that comes home with your new purchase will be a 4 section stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style flaw. Integrated in obsolescence because as soon as it is placed in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any difference. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are really small as they increase from the water surface area. They make their method into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.
It takes place slowly and on a Swim Spa Cover which is made of specific sections, at differing speeds. So ultimately you’ll see one or two of the sections are truly getting heavy. The bar lifters on completions of the swim spa aren’t much help since you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will eventually end up in some garbage dump, they developed one that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or break down at the seams either. So if you own a swim spa, and you plan to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to order today, bookmark this website so you can find it once again when you’re all set!